Myron L Products

contactshipcallwe ship worldwide

Controlstik II System

Controlstik II System

Dual Range Heavy Duty Rinse Tank Control System

FEATURES:
  • IP65/NEMA 4X Rating Water and Corrosion Resistant Enclosure
  • 316 Stainless Steel Hardware
  • Reliable Solid-State Electronics
  • Automatic Temperature Compensation to 25°C/77°F up to 82°C/180°F
  • Valve features Anti-Hammer Closing, Adjustable Flow Control, and Manual Override
APPLICATIONS:
  • Continuous-flow rinse tanks
  • Circuit board manufacturing
  • Electroplating
  • Wastewater
  • Plus many more!

WHAT IT DOES
The Myron L® CONTROLSTIK II™ Rinse Tank System dramatically reduces the amount of water used in continuous flow rinse tanks. At the same time, it automatically maintains optimum water purity, ensuring effective rinsing.

HOW IT WORKS
The three parts of the CONTROLSTIK II System are easily installed. The CONTROLSTIK II (conductivity sensor) is set at a tolerable contamination level and submerged in the tank. Water cannot flow into the tank until drag-in from rinsed parts causes the contamination level in the tank to rise above the pre-set point. The CONTROLSTIK II (sensor) then signals the solenoid valve to open, adding fresh water. As soon as this fresh water dilutes the contamination to the tolerable pre-set level, the CONTROLSTIK II (sensor) closes the valve.

ENGINEERING SPECIFICATIONS
Rinse water usage shall be minimized by means of automatic conductivity control systems. They shall consist of a temperature compensated conductivity sensor, corrosion resistant one-inch solenoid valve, and transformer box which safely reduces line power to the sensor. Enclosure shall be fiberglass with heavy rubber gasket and 316 stainless steel. Circuitry shall be solid-state, and unaffected by changes in voltage. Setpoint adjustment shall be on sensor to minimize tampering. Rinse tank controls shall be Myron L® Model 597 or approved equal.

SPECIFICATIONS

TRANSFORMER BOX:
Input Power:
Choice of 110 or 220 VAC, 50/60 Hz; Automatic voltage regulation insures operation of the systems from 105-125V or 210-250V respectively.
Output: 24 volts @ 600 mA AC
Maximum Power Consumption: @ 117V: 12 watts (103 milliamps)
Enclosure: IP65/NEMA 4X fiberglass case with gasket and 316 stainless steel hardware.
Lights: LEDs indicate POWER (red) and VALVE (yellow)
Electrical Installation: Either HARDWIRE with 5/8 in. conduit; or PLUG-IN with 8 ft./2.4 meter, 18 ga. 3-conductor plug. (supplied with 110V systems only)
Mounting: Flange on enclosure for easy wall mounting
Dimensions: 184 H x 197 W x 127 D mm/ 7.25 H x 7.75 W x 5 D in.

CONTROLSTIK SENSOR:
Ranges: 5-500 micromhos (for high quality water); 500-5000 micromhos (for normal tap water)
Power: 1 volt AC (from transformer box)
On-Off Span: Approximately 5% of setpoint
Temperature Compensation: Automatic to 25°C/77°F up to 82°C/180°F
Materials: Epoxy and 316 stainless steel
Cable: 10 ft./3 meter 22 ga., 4-conductor, vinyl jacketed
Installation: Corrosion-proof ABS bracket supplied
Dimensions: 304 L x 25 Dia. mm/12 L x 1 Dia. in.

SOLENOID VALVE:
Size: 1 in. NPT normally closed; compatible with plastic or metal piping
Power: 24 volts @ 200 mA AC (from transformer box)
Materials Body: glass reinforced nylon; Diaphragm: nylon reinforced BUNA N synthetic rubber. All exposed metal: stainless steel
Operating Pressure: 10-100 psi / 0,69-6,90 bar
Miscellaneous: Adjustable flow control; manual override; anti-hammer closing; conduit connector

Limited Warranty
Myron L® CONTROLSTIK II™ Systems have a Two (2) Year Limited Warranty. If this system fails to function normally, return the faulty unit or the system to the factory prepaid. If, in the opinion of the factory, failure was due to materials or workmanship, repair or replacement will be made without charge. A reasonable service charge will be made for diagnosis or repairs due to normal wear, abuse or tampering. Warranty is limited to the repair or replacement of the units of the CONTROLSTIK II System only. The Myron L® Company assumes no other responsibility or liability.

  • Models: 597, 5972, 597LV, 5972LV, -25, STIK, 024-1, S24, RTCSS, CLPS, VBP, 597BOX, 597BOX2, 597EC, 597FP, RTCM, 597TFO, 597TFO-220 & PCO

Please Choose:
Check the box for the product, then add to the cart.

Controlstik II System








Controlstik II System Special Order Options





Controlstik II System Replacement Parts


















Add to Cart:
Copyright © 2024 GWJ Co. All rights reserved.
Other products and companies referred to herein are trademarks or registered trademarks of their respective companies.
**Prices, images and specifications subject to change without notice.**

PIA Member    D & B Verified

For your convenience, we accept these credit cards:
Credit Card Logos